Latest Imageshttps://irishrailwaymodeller.com/gallery/category/1-member-albums/Latest ImagesenH3.JPGhttps://irishrailwaymodeller.com/gallery/image/959-h3jpg/ H3.JPG

]]>959Wed, 24 Dec 2025 21:40:29 +0000Flat 2..JPGhttps://irishrailwaymodeller.com/gallery/image/958-flat-2jpg/ Flat 2..JPG

]]>958Fri, 02 May 2025 15:01:27 +0000A.JPGhttps://irishrailwaymodeller.com/gallery/image/957-ajpg/ A.JPG

]]>957Fri, 02 May 2025 15:01:26 +0000S coupling rods drilled out to 1.5mm bores for crankpinshttps://irishrailwaymodeller.com/gallery/image/929-s-coupling-rods-drilled-out-to-15mm-bores-for-crankpins/ S coupling rods drilled out to 1.5mm bores for crankpins

]]>929Thu, 06 Oct 2022 09:01:42 +0000S coupling rods being drilled outhttps://irishrailwaymodeller.com/gallery/image/928-s-coupling-rods-being-drilled-out/ S coupling rods being drilled out

]]>928Thu, 06 Oct 2022 08:56:52 +0000Measuring for correct axle lengthhttps://irishrailwaymodeller.com/gallery/image/927-measuring-for-correct-axle-length/ For use on 21mm gauge, the drivers are measured using the back-to-back gauge, across the thickest part of the wheel hub.

Digital calipers read this as 25.2mm, so axles must be cut to this length. Fortunately the same measurement also applies to the bogie axles.

An order for these axles has gone off to Ultrascale. 

Measuring for correct axle length

]]>927Thu, 06 Oct 2022 09:29:11 +0000Driving wheels full set for locohttps://irishrailwaymodeller.com/gallery/image/926-driving-wheels-full-set-for-loco/ Driving wheels full set for loco

]]>926Thu, 06 Oct 2022 09:23:36 +0000G.JPGhttps://irishrailwaymodeller.com/gallery/image/925-gjpg/ G.JPG

]]>925Sun, 02 Oct 2022 21:07:25 +0000H.JPGhttps://irishrailwaymodeller.com/gallery/image/924-hjpg/ H.JPG

]]>924Sun, 02 Oct 2022 21:07:23 +0000Driving wheels for GSR 800https://irishrailwaymodeller.com/gallery/image/923-driving-wheels-for-gsr-800/ Driving wheels for GSR 800

]]>923Tue, 27 Sep 2022 22:31:00 +0000