Loco Lamps 3D Printed

[Chris-Draw]

Loco Lamps 3D printed in 'Clearish' material, so that the Lens can be seen clear, or with a felt tip pen tinted Red. Can be used for Loco's or Brakevans.

I suggest a waft of grey primer first, BUT quickly wipe the paint from the Lens area. Then paint in your favourite colour scheme.

These are for 7mm Scale they have a Tee Slot in the base for fitting to Lamp Irons either sideways or facing front / back. Also a small hole in the rear for fitting to a rod if required.

50p each based on making 20 pieces at one go. 

All the best Chris

https://chris-draw.com