Jump to content
  • entries
    37
  • comments
    83
  • views
    9,354

SLNCR railbus


As you can see from the Models section, my SLNCR railbus is almost complete. It still needs a bit of paint touching up & plus some weathering, but is now looking the part I hope.

Its initial trial run was a bit dodgy, to say the least, but then I realised the wheels hadn't been cleaned, nor the chassis oiled. No surprise that it couldn't pull its trailer and the [undriven] front wheels weren't turning round... However, a bit of fettling and it proved capable of trundling round the layout, albeit a little noisily. Hopefully it will quieten down as it gets run in.

As said before, the chassis is a simple nickel silver 'ladder' type affair, with drive from a small Mashima motor to the rear wheels. The motor intrudes slightly into the body, but seats and a few Slaters passengers help to hide it. The body is nearly all plastic sheet and microstrip, though the nearside mudguard is nickel silver and the rear steps are brass strip, for strength. The roof is balsa, sanded to shape, though the rear entrance section is all plastic.

Main body colour is Halford's 'Ford Laurel Green' spray can acrylic, with the top half brush painted with Model Colour 'ivory' acrylic. Transfers came from my stores box & must be over 20 years old! the luggage van lettering is Woodhead transfers 'pressfix' letter, while the SLNCR is water slide from an SMS 'LMS' sheets, plus the '&' from a Fox sheet. Just goes to show you should never throw anything away.

The other photo is of my fiddle yard. Given the Irish railways predilection for turntables at ever terminus, it seemed to me that a turntable fiddle yard was also merited. Cut from 12mm MDF, with a pivot using an M6 bolt, all seemed very simple until I discovered that my idea of 5 tracks was not possible because the board is only 46" long and the outer curves were far too tight. Indeed, even reducing to 4 tracks has meant I needed to widen the track gauge to around 37.5mm [instead of the nominal 36.75].

Alignment is by home-made bolts, using brass rod & tube, bought on the cheap due to the sad demise of the Modelzone shops. We had two in my area, including the wonderful Signalbox in Rochester & now both are no more. Shame.

The loco turntable on the layout itself is by Dapol, in other words, the old Airfix model. At 250mm diameter, it is ideal for the Sligo tanks, but a bit short for the railcar & trailer, so have fitted extension rails to make life easier & maybe one day enable a small 4-4-0 or 2-4-0 to visit on excursions. It is handcranked using the Frizinghall models kit [very Meccanno-ish & effective]. Will be working on track feed this week, so I can start doing some serious test running before the layout enters its 'scenic ground cover' phase. hopefully more pics of the turntable next week.

0 Comments


Recommended Comments

There are no comments to display.

Guest
Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

Terms of Use