Jump to content
  • 0

Decoder installation in MM141

Rate this question


Question

Posted

Lads, I've added a decoder to the MM141. Its a loco cruiser LC205. I stuck it in in the same orientation as the blanking plate that I removed. But its not being read. How do I tell if its the right way round, a dud, or a problem with my kit build DCC rig?

 

Ger

2 answers to this question

Recommended Posts

  • 0
Posted (edited)

The DCC plug on the loco PCB will be missing one pin (i.e. have 21 instead of 22), and the DCC socket on the decoder chip will have one of the pin sockets blocked off (i.e. so a pin cannot go through it and only 21 holes open).  It should look like orientation in the photo below.  This is to prevent folk plugging the chip in the wrong way around 

76016BA7-2AF5-4CA9-8BC4-0D9FBA65FF2C.jpg

 

See the missing pin below on the lower left side of the DCC plug on the loco PCB.  

EB08248D-43DF-48D8-BEE3-FD21F5FFE63E.jpg

 

Here's another angle of a 21pin lenz decoder installed

MM182a.jpg

Edited by Noel
  • Informative 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

Terms of Use