signal part needed not sure what to use.

[Buz]

Hi all

This one is very shades of Madder Valley I need a lamp casting to finish this signal.

I need a large old world type signal lamp with a single lens so I can finish the signal.

Any suggestions would be welcome as to where I might get one the signal is nominally 4mm scale,

but very much shade's of Madder Valley while still being loosely based on "ye olde" signalling practices.

It's for the other project and has been sitting around unfinished long enough and I want to get the original long match stick and too small target version replaced.

I originally thought old Triang Hydraulic buffer lamp.

But don't have one I can rob in the junk box and it might not be quite big enough for an early lamp housing.

So really any suggestions for  a) what to use and b) where to get one would be most welcome.

regards John

[David Holman]

Try Wizard Models, who have an extensive on line catalogue and ordering service for signalling parts.

[Buz]

4 hours ago, David Holman said:

Try Wizard Models, who have an extensive on line catalogue and ordering service for signalling parts.

Thanks interesting load of bits and pieces and a lot of pages to look at.