Trying - and failing - to Reset

[Patrick Davey]

Hi all - I previously mentioned that I had an issue with my IRM A class locos in that the cab lights and main headlights won't illuminate at the same time.  This is only an issue with my 3 sound chips (1 EMD and 2 Crossley), and is not an issue with my sole A class standard chip, where both sets of lights can be successfully illuminated together.

@BosKonay suggested a factory reset of the chip (sound version) so I have been trying that, with no success, but tbh I am not totally sure that I am doing the reset properly.  CV settings are something of a mystery to me.....

Would someone be able to post a 'for Dummies'-type instruction for this, I am using an NCE Power Cab controller.

Thanks!

Edited July 27 by Patrick Davey

[BosKonay]

If you can write CV’s just write the value 8 to CV8 then power down and power up the loco (allow a minute for the stay alives to drain) and you should end up with a factory reset. Any trouble just drop a line or live chat to support