Maam Road/Bóthar an Mháma

[Mol_PMB]

Another tip for square open-topped water tanks - they usually had internal bracing to resist the water pressure pushing the sides outwards. 

Although not Irish, this webpage shows some typical examples:

NSW Railways Infrastructure and Operations: What’s on the inside (of those water tanks)

Tricky to model, and you can get away without it by either modelling the tank brim-full (which it normally would be except when a loco has visited recently), or by roofing the tank (which was sometimes done to prevent leaves accumulating inside).

[jhb171achill]

8 hours ago, Irishrailwayman said:

Just a note to file on a suggested painting scheme for the water towers. First coat all exposed wood with Rustins grey primer/undercoat. Next "dry brush" with Humbrol #64 Light Grey matt (ie use small amounts of paint on a flat brush wiping it almost dry on kitchen paper before skimming across the "stones" avoiding flooding the "mortar" lines between). Pick out individual stones with Humbrol #27 Sea Grey matt. For woodwork, windows and door use Humbrol #80 Grass Green matt. For "yellow" brickwork lightly paint to avoid flooding the "mortar" lines with RailMatch #606 GWR Light Stone (Humbrol #121 Pale Stone matt would work either). For red brickwork use sparingly 50:50 mix of Humbrol #73 Wine matt and #62 Leather matt.

For the 3-D printed water tank streak sides with Humbrol # 113 Rust; insert clear plastic to fit, paint underneath with Humbrol #80 Grass Green matt and streak with Humbrol #113 Rust matt (could also paint blue/brown as colour in reality would be dictated by overhead light conditions). I used a section of 5 mm plastic tubing and some heat-shrink tubing to represent the water outlet leather bag which flops in to the receiving steam engine water intake point. I fitted small sections of clear plastic behind the windows with DeLuxe Glue& Glaze as glazing.

I’m going to print that off as a guide!!