Jump to content

Possible 3D printed NIR 80 Class bodyshells in the offing…

Rate this topic


Recommended Posts

Posted (edited)

Spotted on eBay

just in case IRM don’t follow their Mk2 coaches with this Mk2-based DEMU.

Cheers

Darius

PS just to clarify, I am not connected to the production of these bodyshells, I just spotted them on eBay.  They are made by CMAC models (m0rris on this website).

Edited by Darius43
  • Like 5
  • 3 months later...
Posted

Hi 

Ordered a pair end of last week from CMAC, so hopefully a quick bit of yellow  and a sandite will make progress. However was was good to note a 450 class had been created and two sets sold already £149 iirc. So two  happy bunnies somewhere.  CMABC did helpfully suggest it would be possible to order just motor cars so a sandite much easier. Hopefully a good match to my Lima reworkings of MK2 DTS / TS vehicles.

Robert    

  • Like 1
Posted
29 minutes ago, Robert Shrives said:

Hi 

Ordered a pair end of last week from CMAC, so hopefully a quick bit of yellow  and a sandite will make progress. However was was good to note a 450 class had been created and two sets sold already £149 iirc. So two  happy bunnies somewhere.  CMABC did helpfully suggest it would be possible to order just motor cars so a sandite much easier. Hopefully a good match to my Lima reworkings of MK2 DTS / TS vehicles.

Robert    

I am looking forward to following your progress on these Robert. 

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

Terms of Use