Steel bridge quest

[Gabhal Luimnigh]

Well lads and lassies, anyone here got a 3d printer or the like? I am looking for two sides of a steel road bridge for my layout, I am hoping to do something like the picture below, can anyone assist please?

 

[Broithe]

Could you adapt this sort of thing?

https://www.ebay.co.uk/itm/402229496940

[Gabhal Luimnigh]

27 minutes ago, Broithe said:

Could you adapt this sort of thing?

https://www.ebay.co.uk/itm/402229496940

Yep

[Tullygrainey]

These any good?

[Billycan]

Or perhaps this one

Plate Girder Bridge Side – PECO (peco-uk.com)

[Gabhal Luimnigh]

10 minutes ago, Tullygrainey said:

These any good?

Yes sir 

11 minutes ago, Tullygrainey said:

These any good?

 

7 minutes ago, Billycan said:

Or perhaps this one

Plate Girder Bridge Side – PECO (peco-uk.com)

A bit long but adaptable 

[Gabhal Luimnigh]

Any of you got any of these going spare? Even one side? I'd rather buy it here than going through all the postage from the UK palava

[Sean]

You should be able to get the peco one along with a few others from marks models.

 

failing that, the UK situation is still tolerable if you use a service like addresspal.

[derek]

4 hours ago, Gabhal Luimnigh said:

Any of you got any of these going spare? Even one side? I'd rather buy it here than going through all the postage from the UK palava

Denis, I could make two sides for you if the standard of my one on my layout would be ok. If you think it is rubbish, just politely refuse. Free of charge of course. You were good enough to offer me a bus you had a couple of weeks ago. If you prefer patented products, it's all good.

[DJ Dangerous]

Nice one, @derek, that's bang on!

These any use?

https://www.marksmodels.com/?pid=16306

In stock with Marks Models.

 

 

[Gabhal Luimnigh]

1 hour ago, derek said:

Denis, I could make two sides for you if the standard of my one on my layout would be ok. If you think it is rubbish, just politely refuse. Free of charge of course. You were good enough to offer me a bus you had a couple of weeks ago. If you prefer patented products, it's all good.

Derek your rubbish is my gold, I would greatly appreciate it lad, patented products are grand but one offs are better

33 minutes ago, DJ Dangerous said:

Nice one, @derek, that's bang on!

These any use?

https://www.marksmodels.com/?pid=16306

In stock with Marks Models.

 

 

They are N gauge by the looks of it 

[DJ Dangerous]

Sorry, wrong one, was rushing.

https://www.marksmodels.com/?pid=11520